Bridges
Bridge Engineering Designs and Working Drawings.The AutoCAD drawings in this section contains: design general notes, typical bridge cross section, abutment formwork, abutment pile cap, wingwall reinforcement, pier pile cap details, beam reinforcement details, insitu-slab reinforcement, precast slab reinforcements, abutment pile reinforcement details, and varieties of miscellaneous details for all reinforced concrete bridge. Bridges
36m Bridge detail drawings
This is a detailed 36m Bridge detail drawings. Design drawings of reinforced concrete bridge prestressed. Contains all needed drawings….
Box Girder Tendons Detail Drawings
The foundations of the piers have a uniform thickness of 3.20 m; dimensions in plan are 10.00 m along the bridge. For each foundation 20 piles are used…
More Details
For each foundation 20 piles, 1,500 mm in diameter are used. Contains Thirty AutoCAD files
Box Girder Bridge Piers Drawing
A single wall having a rectangular cross section 5.50 m wide and a thickness varying between 1.2m at the base and 0.6m at the top also make some piers.
More Details
The piers 3 and 25 are double walls piers with spherical/sliding supports on the top. The other piers have double walls continuous with the upper box girder beam. Contains Thirty AutoCAD files
Typical Box Girder Calculations Design
This files contains contains the statistical structural calculations for the entire bridge design. Its a word document of 198 pages!
More Details
Inclusive are also the bridge bearing and emergency stop details. Contains Twenty AutoCAD files plus over 300 pages of design calculation in word document format.
Box Girder Typical Bridge Layout
This drawing- set consists of the general layout of the box girder bridge sowing the plan, profile and cross section of the bridge…
More Details
The box girder has a depth varying from 5.50 m at the piers in water to 2.85 m in the middle of the 95‑m spans. Alignment layout and cross slopes are inclusive in these AutoCAD drawings.
Box Girder Abutment Drawings
The abutments are of the total earth retaining type and have a front face, on which are located the steel-teflon bearings supports, and two lateral walls…
More Details
...which extend towards the rear of the abutment with two ears. The front face and the lateral walls are self-bearing, with cantilever functioning with anchorage on a single raft foundation. Contains twelve AutoCAD files
30m Length Bridge Design and Drawings
The length of the respective bridges is 30.00Lm. The deck slab is 250mm thick and spans over 5No. pre-cast reinforced concrete beam girders 15.0Lm long,
More Details
...1.0m deep and 450mm wide. The abutments are made up of a frontal wall 600mm thick and two lateral wing walls separated by a cellotex board filled expansion joint.
Reinforced Concrete Beam Bridge
The carriageway is 8 m width, flanked by 1500 mm walkway with a parapet wall on one side and 800 mm safety kerb on the other.
More Details
This is bridge is overlain with 50 mm layer of asphaltic concrete surfacing. Contains Twenty AutoCAD files.
Updating...
